Suspended Ceiling Contractors

Suspended Ceiling Contractors

Lighting, Hatches and Integration

Fitting LED panels, downlights, air-conditioning grilles, access hatches and sensors neatly into suspended ceilings.

Free Suspended Ceiling Contractors quote

No obligation. We only use your details to reply about this job.

Lighting, Hatches and Integration — Suspended Ceiling Contractors

What's involved

Suspended ceilings carry far more than tiles. LED panels in 600 x 600 or 1200 x 600 mm sizes drop straight into the grid in place of a tile, connected by an electrician. Downlights, PIR sensors, smoke detectors, speakers and air-conditioning cassettes are cut into tiles or framed in the grid with additional support, as the grid is not designed to carry heavy loads on its own. In MF ceilings, access hatches are framed in so valves, dampers and junction boxes remain reachable. Coordination with electricians and mechanical engineers is key, and the ceiling contractor sets out the grid so fittings land centrally. Integration adds time depending on fitting numbers. You need to provide lighting and mechanical layouts before the grid goes up.

How we handle it

  1. Share your project

    Use the quote form to tell us the building type, floor area, ceiling type wanted and any timing constraints. Drawings or photos of the existing ceiling help us brief the right contractor.

  2. Survey and specification

    A contractor surveys the soffit, checks heights, services and access, and recommends the grid, tile or board system. You receive a fixed written price.

  3. Set out and hang

    The ceiling height is set by laser, perimeter trim fixed and hangers installed into the structure at the correct centres.

  4. Grid, board and integrate

    Main runners and cross tees or MF channels are installed, services and lights coordinated, then tiles laid or plasterboard fixed and finished.

  5. Clean and hand over

    Tiles are checked for alignment, fittings tested by the relevant trades, waste removed and the area cleaned ready for occupation.

Price guide

Suspended ceiling prices are usually quoted per square metre and depend on the system, tile specification, ceiling height and how much lighting and services integration is needed. Small areas cost more per square metre because setting up takes the same time. Night or weekend working is priced separately. Every quote is fixed after survey.

  • Standard grid ceiling with tiles: £22–£38 per m². 24 mm white grid and standard mineral tiles on an open floor at normal height.
  • Small room grid ceiling: from £450. Minimum job for a single small office, kitchen or utility area.
  • Strip out of existing ceiling: £6–£12 per m². Removing tiles, grid and hangers and disposing of non-hazardous waste.

Questions about lighting, hatches and integration

What is a suspended ceiling?

A suspended ceiling is a secondary ceiling hung below the structural ceiling on wire or rod hangers. The gap above, called the ceiling void, hides pipes, ducts and cables while keeping them accessible. The two main types are exposed grid ceilings with lift-out tiles and concealed MF ceilings boarded with plasterboard.

Can suspended ceilings be fire rated?

Some suspended ceiling systems are tested to provide fire resistance as a complete assembly, but most standard grid ceilings are not. Where fire resistance is needed, the specification must use a tested system installed exactly as designed. Tiles and boards must also meet surface spread of flame requirements for the building use.

Can lights be fitted in a suspended ceiling?

Yes. LED panels drop directly into the grid in place of a tile, and downlights, sensors, speakers and air-conditioning grilles can be cut in or framed. Heavier fittings need independent support so they do not overload the grid. An electrician connects the lighting after the grid is installed.

Get a free suspended ceiling contractors quote

Tell us what you need and we'll come back with a clear price.

Request a quote