Suspended Ceiling Contractors

Suspended Ceiling Contractors

Ceiling Tile Replacement

Swapping stained, sagging, damaged or discoloured tiles in existing grids to refresh offices, shops and common areas.

Free Suspended Ceiling Contractors quote

No obligation. We only use your details to reply about this job.

Ceiling Tile Replacement — Suspended Ceiling Contractors

What's involved

Water stains, sagging and yellowing are the usual reasons for replacing tiles. The fixer identifies the tile size, grid width and edge detail, whether square edge, tegular or microlook, so replacements sit correctly. Where only a few tiles are damaged, matching tiles are sourced, though new tiles can look brighter than aged ones nearby. Replacing all tiles in a room gives a consistent finish and is often cheaper per tile. Bent or rusted grid sections are straightened or replaced at the same time. Before removal, the cause of staining should be fixed, such as a leaking pipe or air-conditioning condensate. Older tiles may contain asbestos, so they should be checked before removal. A typical office floor is retiled in a day. You need to clear desks and protect equipment below.

How we handle it

  1. Share your project

    Use the quote form to tell us the building type, floor area, ceiling type wanted and any timing constraints. Drawings or photos of the existing ceiling help us brief the right contractor.

  2. Survey and specification

    A contractor surveys the soffit, checks heights, services and access, and recommends the grid, tile or board system. You receive a fixed written price.

  3. Set out and hang

    The ceiling height is set by laser, perimeter trim fixed and hangers installed into the structure at the correct centres.

  4. Grid, board and integrate

    Main runners and cross tees or MF channels are installed, services and lights coordinated, then tiles laid or plasterboard fixed and finished.

  5. Clean and hand over

    Tiles are checked for alignment, fittings tested by the relevant trades, waste removed and the area cleaned ready for occupation.

Price guide

Suspended ceiling prices are usually quoted per square metre and depend on the system, tile specification, ceiling height and how much lighting and services integration is needed. Small areas cost more per square metre because setting up takes the same time. Night or weekend working is priced separately. Every quote is fixed after survey.

  • Strip out of existing ceiling: £6–£12 per m². Removing tiles, grid and hangers and disposing of non-hazardous waste.
  • Small room grid ceiling: from £450. Minimum job for a single small office, kitchen or utility area.
  • Standard grid ceiling with tiles: £22–£38 per m². 24 mm white grid and standard mineral tiles on an open floor at normal height.

Questions about ceiling tile replacement

What is a suspended ceiling?

A suspended ceiling is a secondary ceiling hung below the structural ceiling on wire or rod hangers. The gap above, called the ceiling void, hides pipes, ducts and cables while keeping them accessible. The two main types are exposed grid ceilings with lift-out tiles and concealed MF ceilings boarded with plasterboard.

How much does a suspended ceiling cost per square metre?

A standard grid ceiling with mineral tiles typically costs £22 to £38 per square metre installed. Acoustic or premium tiles raise this to £35 to £60. MF plasterboard ceilings usually cost £40 to £70 per square metre. Small rooms cost more per square metre because set-up time is the same.

What size are suspended ceiling tiles?

The most common size in the UK is 600 x 600 mm, which fits a standard 24 mm grid. 1200 x 600 mm tiles are also widely used, especially with LED panels. Tiles come in square edge, which sits flush with the grid, and tegular edge, which drops slightly below it for a more refined look.

Get a free suspended ceiling contractors quote

Tell us what you need and we'll come back with a clear price.

Request a quote